Designed for faster material removal and higher overload protection

Before connecting the tool to a power supply, be sure the switch is in the off position by pressing the rear part of the switch and releasing. 

Ensure the switch is in the off position as described above after any interruption in power supply to the tool, such as the activation of a ground fault interrupter, throwing of a circuit breaker, accidental unplugging, or power failure. 

To start the tool, slide the ON/OFF switch L FIG. 6 (L) toward the front of the tool. 

To stop the tool, release the ON/OFF switch. 

For continuous operation, slide the switch toward the front of the tool and press the forward part of the switch inward. 

To stop the tool while operating in continuous mode, press the rear part of the switch and release.