Orbital sander (+finish & detailer)

Manual

• DETAIL SANDING 

Your sander is manufactured with the detail/finishing sanding pad installed. This pad is equipped with a detail pad tip for sanding tight spots or corners. 

The sandpaper tips and the detail pad tip may wear unevenly, depending on use. This tool allows you to rotate the sandpaper tip, the detail pad tip, or both. 

To rotate the detail pad tip, remove the detail pad tip, rotate it, and press it back on the platen. NOTE: It is not necessary to loosen the screw to rotate the detail pad tip.

• FINISHING SANDING 

For sanding larger areas, reverse the detail/finishing sanding pad 

• Unscrew the bolt on the bottom of the sanding pad using the hex wrench included with your tool. Remove the pad and washer.

• Place the pad back on the tool as shown in Fig. 3. Align the four posts on the pad with the four recesses in the tool, and press posts firmly into the recesses. Replace the washer and bolt. Securely tighten the bolt using the hex wrench. 

• To return the sander to its detail sanding mode, repeat the above instructions but place the detail tip of the pad toward the front of the tool.

• RANDOM ORBIT SANDING 

Your sander is also includes a round random orbit sanding pad. For random orbit sanding, install the round sanding pad.

• Unscrew the bolt on the bottom of the sanding pad using the hex wrench included with your tool. Remove the pad and washer.

• Place the random orbit sanding pad on the bottom of the tool, with the hook and loop side facing away from the tool . Replace the washer and bolt. While holding the pad with one hand, securely tighten the bolt using the hex wrench